The paper presents the results of an experimental investigation on the machinability of fabricated aluminum metal matrix composite (A356/SiC/10p) during continuous turning of composite rods using medium grade polycrystalline diamond (PCD 1500) inserts. MMC's are very difficult to machine and PCD tools are considered by far, the best choice for the machining of these materials. Experiments were conducted at LMW-CNC-LAL-2 production lathe using PCD 1500 grade insert at various cutting conditions and parameters such as surface roughness, specific power consumed, and tool wear were measured. Machining was continued till the flank wear land on the tool crossed 0.4 mm. The influences of cutting speed on the insert wear and built-up edges (BUEs) formation were studied. The present results reaffirm the suitability of PCD for machining MMCs. Though BUE formation was observed at low cutting speeds, at high cutting speeds very good surface finish and low specific power consumption could be achieved. © 2007 Springer-Verlag London Limited.