Abstract The aim of this work was to study the effect of two solvents such as N,N′-dimethylformamide (DMF) and dimethylacetamide (DMAc) used in the production of polysulfone (PSf) and polyurethane (PU) blend ultrafiltration membranes, influence permeability and selectivity. PSf/PU membranes were prepared by the phase inversion method using polymer concentrations of 100/0, 20/80 and 0/100 wt%. Permeation performance of the prepared membranes was evaluated in terms of pure water flux, water content and hydraulic resistance. It was found that the membrane composed of 20/80 wt% of PSf/PU in the presence of DMAc showed a water flux of 60.5 l m -2h-1 under transmembrane pressure of 345 kPa, and the water flux of 23.5 l m-2h-1 for 20/80 wt% of PSf/PU in the presence of DMF. With increasing the polarity of DMAc in the casting solution, an increase in porous layer thickness was observed, and then a good water flux of membranes can be obtained. It was found that the polar solvent caused the rapidly demixing of casting solution in coagulation bath and formed porous asymmetric membranes with defective skin layer. The permeation rates of proteins were measured with different molecular weights of the proteins.